Saturday, October 5

Beautiful B-17 Engines & enhancements for your German AFS from SBS Model...

SBS Model Hungary have a bunch of new improvements for both your HK B-17 & 250/259 halftracks in 3D & resin casts just in time for launch at the Scale Model Challenge event. See them closer in our preview...


Beautiful B-17 Engines & enhancements for your German AFS from SBS Model...

SBS Model have j just released a bunch of 3D printed armour sets in 1/35 and one aircraft set in 1/32 to be released for SMC - these look waaaay better than the original parts, so you'd best be included to take a look!

B-17 F/G Engine upgrade set for HK Models kit
From SBS Model
Designed by Flying Octopus Design by Otto Jozsa
Kit No #32002
1/32nd scale
Price:  54€
These four 3-D printed resin complete engines are made to fit the Hong Kong Models 2nd scale B-17 kit. Wiring, seamless parts that only need to be remove from their casting blocks before installation. these are a definite upgrade to anyone's kit.


Sd.Kfz.250 (Alte) Adjustable frontal axle for Takom kit
From SBS Model
Designed by Flying Octopus Design by Otto Jozsa
Kit No #3D039
1/35th scale
Price: 28€
This set is made from 3-D printed resin & must be removed from its supports to use. However, this set takes away removing of the seams and gives you a posable front axle for the Takom Sd.Kfz.250 (Alte) kit. It gives detail at a very prominent place on the kit.


Sd.Kfz.250 (Alte) Sprocket for Takom/Dragon kit
From SBS Model
Designed by Flying Octopus Design by Otto Jozsa
Kit No #3D040
1/35th scale
Price: 14€

The drive sprocket for the Sd.Kfz.250 (Alte) Takom/Dragon kit's is improved with this 3-D printed part. There are one for the left and right side provided, with the casting texture recreated in this print. a single part to just drop in place.


Radio Equipment Sd.Kfz 250/9 - Sd.Kfz 234/1 - Sd.Kfz 140/1
From SBS Model
Designed by Flying Octopus Design by Otto Jozsa
Kit No #3D041 
1/35th scale
Price: 12€
This detailed radio set for the Sd.Kfz 250/9 - Sd.Kfz 234/1 - Sd.Kfz 140/1 is created in 3-D printed resin. As you can see in the images, it comes on printing supports which need to remove. A small price to pay to have such detail at your fingertips after 10 mins or so work!

These kits will debut at Scale Model Challenge this month , and the sets are up on the SBS website.